Ambient Weather WS-2902-ARRAY Replacement Sensor Array

works as it is advertised. easy to install and calibreate. thank you

Fixed my issue. Easy to setup, could be less expensive.

I absolutely love this Ambient weather station. This is the 2nd one I've owned. I'd still be on my first one if I had not dropped it...my bad. But I've been using this model for years and just love it. Easy to mount, easy to pair to the console and as accurate and durable as any out there. The batteries lasted me 5 years, the rain totals and counts are accurate as are wind speeds, direction, temps and etc. Really enjoy this hobby.

I bought this model previously with the complete console and was very pleased with it. It's located at remote location near my farm and it's nice to be able to check rainfall and weather online. It connected to online sites without any issues. My original one that I bought as a complete package with the console, worked well, but lasted less than 3 years. Suddenly I was no longer receiving a signal. We checked and one of the arms of the anemometer had broke off and neither rebooting or new batteries restored the connection. Pro's: It connects to the internet and provides useul information. It was great that I could buy just the weather station alone as a replacement without replacing the entire system. Cons: I really hoped the original would have lasted more than 2 1/2 years. There was no apparent evidence of physical damage from tree branches or other sources that could have cause the damage.

This is a replacement array for my WS2000. The inside screen still worked fine. The inside temp, day and wifi still had readings. The outdoor sensors after 3 years florida heat, no longer worked. This array seems to be an exact fit. The setup was not difficult. My old array solar panel was completely dead, which made the disconnect easier. Go into settings, more, sensor and find and disable the old array. The old array model number is on bottom right side of array. Then put batteries in new unit keep new unit near panel. Go back into settings and under the same sensor enable. Push the reset button on bottom of new array, red light will flash on opposite side. Unplug the new side panel screen, to reboot. In a few minutes it should find the new array and it will now be listed in same fashion as the old array was.

Look at it every day and rely on it for local info. Rain gauge catches fir needles and plugs up. This is a replacement for one that last 7 years. The old one finally leaked into the base and shorted the board.

I bought this to replace my original WS-2902 array that was 4 1/2 years old. After moving I noticed that the case had a crack and the wind sensor axle was bent. This replacement was just like the original. It did not automatically get detected by the console, I had to hold the light/snooze button forcing it to re-detect. I actually had to do that twice and then everything worked. I have had to tape the battery door closed. Although it seems secure it eventually comes open. The batteries last for years.

I have had an Ambient 2902 Weather Station for a number of years. The outside unit was damaged by a tornado that took out our roof and several windows. I was looking for a replacement when I ran across the outside unit being sold separately. I purchased it to save a few bucks. It synced up with my older console and has been working great.